Force satellite receiver manual






















The satellite will search for and acquire satellites. If not already activated, the receiver will need to be activated (see fig. 3). To activate the receiver, call Winegard Company at After the receiver has been activated, the receiver will begin acquiring signal (see fig. 4) . It can also be configured using L-band satellite, thus it is known as FBCB2 Blue Force Tracking (BFT). The system also has a connection to a Global Positioning System receiver for self-location and feeds into the Global Command and Control System. This manual will help you to install, use and maintain the receiver. Please read this manual carefully before operating your unit and keep it for future reference. Thank you for purchasing DVBS2 CA Digital Satellite Receiver. Warning Note In this manual, pay special attention to the following marks that indicate hazardous situations.


XDS-PRO Satellite Receivers 3 www. R, REV. C www.doorway.ru TOLL FREE Document Revision History Revision Date Description ECO# A 10/11/11 Initial release for PRO1Q and PRO4Q models, Firmware v In most receivers, the setup is done through the “Repeat Satellite Setup” option in your receiver menu. To access the “Repeat Satellite Setup” option, go through the following steps. The following instructions are based on an H24 receiver. If your receiver differs from the options shown below, you may need to consult your receiver manual. receiver will need to be set up for that satellite. If the primary receiver changes to a channel on a different satellite, the secondary receiver will lose reception and need to complete setup again on the new satellite. NOTE The secondary receiver’s program guide will only download and display available channels from the installed satellite.


satellite TV receiver (collective or domestic). ▻LNB Drain (available for terrestrial and satellite band). The LNB drain option shows the voltage and. ** Signal Detection You can display the percentage of signal strength and quality. ** Humax SW Update You can update software automatically or manually. When. Is it possible to choose a specific Transponder on which to mount the antenna to receive the signal; Strength and Quality indicators are shown.

0コメント

  • 1000 / 1000